1940 PTFF Pillow Tank Fabric
Commercial Specifications for Urethane Coated Fabric
|
|
|
|
|---|---|---|
| Base Fabric Type |
Nylon |
|
| Coated Fabric Weight (nominal) |
40.0 oz/yd2 |
13556 g/m2 |
| Thickness ASTM D751 |
40 mil (nominal) | 1.02 mm (nominal) |
| Tongue Tear ASTM D751 |
70/50 lbf | 311/222 N |
| Strip Tensile ASTM D751, Procedure B |
700/600 lbf/in min | 613/526 daN/5 cm min |
| Adhesion ASTM D751, Dielectric Weld |
50 lbf/in min | 44 daN/5 cm min |
| Hydrostatic Resistance ASTM D751, Procedure A |
600 psi min | 4.14 MPa min |
| Bursting Strength ASTM D751, Ball Tip |
1200 lbf min |
5340 N min |
| Low Temperature ASTM D2136 1" mandrel, 4 hrs |
Pass @ -50° F | Pass @ -46° C |
| Dead Load ASTM D751 |
2 in seam, 4 hr, 1 in strip 200 lbf @ room temp 100 lbf @ 160° F |
5 cm seam, 4hr, 2.5 cm strip 890 N @ room temp 445 N @ 71° C |
| Permeability ASTM D814 |
Contact Seaman Corporation Technical Support for assistance: 800-927-8578 | |
We believe this information is the best currently available on the subject. We offer it as a suggestion in any appropriate experimentation you may care to undertake. It is subject to revision as additional knowledge and experience are gained. We make no guarantee of results and assume no obligation or liability whatsoever in connection with this information. In case of conflict between standard and metric specifications, standard shall apply.
